# Abraham Weissman 3DT

** Back to 3D Digital Thinking Main Page **

## Contents

## Assignment 1: Tiling

## Assignment 2: Variable Grid

## Assignment 4: Recursion

## Midterm Project

## Assignment 6: Surface Components

Subcurve is component that allows you to divide a curve and only use a section of it. It has two inputs "C" and "D". C: asks of curves, you can put any number of curves in to "C". D: is domain which is the number that your curves are divided by. In this case i put a number slider into"D" to make the number of divisions variable. Subcurve then outputs the subdivided curves.

## Final Project: Grappling Hook Building Block

This is a single leg of the Grappling Hook it sits a 30 degree angle to the ground, one end is cut at two 45 degree angles in order to fit four pieces together (this angle is variable to change depending on number of prongs desired) the other end is cut at a 60 degree angle in order to make its flat end at a 90 degree angle to the ground